خلاط الصب
The pouring machine is mainly used to stir the slurry, cement, quicklime, gypsum and aluminium powder paste suspension liquid injected into the tank according to a certain ratio, so that they are uniformly mixed, fully reacted, and the mixed slurry is injected into the mould frame in time
قوة المحرك: 18.5-45KW
Pouring mixer volume: 4-4.8m3
Application field: It is widely used in the mixing of cement, fly ash and other powdery materials in various engineering constructions.
Performance characteristics of pouring mixer
1. The measured various materials were fully stirred evenly to reach various physical and chemical indexes of pouring. The equipment is divided into: fixed type and mobile type various requirements user requirements.
2. Integrated sealing and hoisting design, convenient transportation and installation, and strong mobility. It adopts a container-type seal design, which can be used in both ground grouting stations and temporary grouting stations, which is convenient for transportation and installation.
3. The pulping machine has its electric control system, no additional power distribution is needed, and the automatic pulping can be started by connecting the main cable, and the installation and debugging are simple. It can also be networked with the host computer in the central control room, with remote control and near control functions.
4. The transmission part of the pulping machine adopts a mechanical seal, which has a long service life, simple maintenance and a good sealing effect. The whole pulping process will not produce the phenomenon of dripping and dew slurry. Environmental protection and sanitation, the entire venue is very tidy.
Pouring mixer working principle
Feed the fly ash slurry or mixed slurry by the slurry pump into the mixing box, and start the mixing motor, the blades begin to rotate at high speed because the blades are inclined at a certain angle, and the slurry and other dry powder materials are pressed to the bottom of the box together when rotating. Turn up from the circumferential box wall.
To prevent the slurry from rotating on the box wall, 4 damping plates are installed on the inner wall of the box to prevent the slurry from flowing in a circle, and the slurry and other dry powder materials are forced to roll up and down. Circulating flow to achieve the purpose of uniform mixing.
When the slurry in the material box is evenly mixed, start the walking motor, and the planetary cycloid reducer drives the chain to drive the active axle to rotate, so that the pouring machine travels to the assembled mould frame, opens the butterfly valve to start pouring, and the pouring is complete After that, the flat car returns to the original fixed position, and a pouring cycle is completed.
Specification of pouring mixer
| اسم | وحدة | Technical parameter |
| Volume of the mixer | m3 | 4/4.8 |
| Shaft rotating speed | r/min | 210/312 |
| Bridge crane speed | m/min | 10-20 |
| Motor power | kw | Shaft rotating speed |
